Product Description Alibaba hot Waste Tyre Recycling to Oil and Carbon Black 1.Raw material:waste tires, waste plastisc or waste rubber2.Final products:Fuel oil,carbon black,steel wire(only when raw material is waste tires)

3.Fuel for heating:Coal/ natural gas/ wood /diesel /oil

Picture of fuel oil and carbon black Waste Tyre Recycling to Oil and Carbon Black

The usage of output products Waste Tyre Recycling to Oil and Carbon Black

Name	Percentage	Usage
Fuel oil	48%-52%	Widely used as fuel oil in industries such as steel and iron factories, ceramics or chemical industries or hotels, restaurants etc. or used for generators to get electricity.
Carbon black	32%-35%	*Be made into carbon black through grinding machine. *Be made into carbon pellet through carbon pellet machine. *can be sold directly.
Steel wire	12%-15%	*can be sold directly; *make steel bloom through hydraulic press-packing.
Oil gas	3-5%	*can heat the reactor as fuel.

The information of mainly parts Waste Tyre Recycling to Oil and Carbon Black

Reactor	1.Made by Q345R boiler plate.Its melting point is 1000°C. 2.Auto-welding both inside and outside. 3.With rock wool insulation board.
Auto-feeder	1.50ton hydraulic pressure. 2.Can feed all types of material. 3.Save labor and save time.
Catalyst chamber	1.Improve oil yield and oil quality. 2.Reduce the speed of oil gas so that it can be better cooled.
Oil-water separator	1.Separate oil and water 2.Collect heavy oil 3.Water sealing design keep safety.
Condenser	1.the oil gas is cooled separately by small pipes inside condenser. 2.Light oil is collected here.
Vacuum device	Keep machine running under normal or micro negative pressure.
Anti-back fire device	1.Recycle residual gas to furnaces as fuel. 2.Water sealing design prevents tempering.
Duse removal device	Dispose of flue gas caused by using coal,wood,oil natural gas.

This is installed machine in our factory. Welcome to visite our factory.

Reactor Waste Tyre Recycling to Oil and Carbon Black

The sealing is very for reactor's service life. Our reactor is welded by four times.The X-ray detection and heat treatment can assure the welding quality and no gasleak.

Automatic welding and manual welding.

The cooling system decides the rate of oil yield. The better cooling effect, the higher rate of oil yield.

Our cooling way is cooling pipe with circulating water

	Number of cooling pipe	Diameter	Length	Cooling area
Two Horizontal condensers	182	48mm	3000mm	3.14*0.048*3*91*2≈82.3m2
Two waste gas condensers	18	48mm	3000mm	3.14 *0.048*3*9 *2≈8.14 m2

Safety device

Wste Tyre Plastic Recycling Plant

No pollution-the gas from chimney is totally clean and can reach europe standard.

Packaging & Shipping

2200*6000	two 40HQ containers
2200*6600
2600*6000	one 40FR open container and one 40HQ container
2600*6600
2800*6000
2800*6600

Application on site Waste Tyre Recycling to Oil and Carbon Black

Goods in stock Waste Tyre Recycling to Oil and Carbon Black

Our distillation machine can turn fuel oil into diesel and gasoline.

Our Services

Pre-sale service Pyrolysis Tire Recycling Machine

1.Offer information of our product.

2.We an help you with the market research and finacial analysis.

3. Various consultation waysuch as Email,Tel,Mob and so on.

The warranty and after service

1. We will supply the foundation drawings to buyer after getting deposit.

2. We will send engineers to install the machine when the machine reach buyer's

factory. The engineer will install and guide the machine, then training the workers

for buyers.

3.Main parts’ life is 1 years from complete installation.

In this warranty period, we supply free service if you have any questions. The

reactor life is more than 6-8 years based on correct operation and maintain, others

parts no need change lifelong except the wearing parts.

Company Information

1.We have been specialized in manufacturing these plants since1985.

2.53000 square meters running factory.

3.Laboratory can test kinematic viscosity, flash point and other aspect of the fuel oil.

4.We holds that Customers Supreme, Services Prior, Practical and Innovative”.

Our factory-Henan Xinfeng Heating Power Co., Ltd.

FAQ

1. How to deal with the waste gas?

The extra waste gas could not be emitted directly in the air, as it would get accumulated in the surroundings, and even a single spark can lead to blast. The waste gas is transferred back to the heating chamber to heat the reactor as fuel. During this period, the whole plant only cost little coal. It is hard to store this waste gas, because this gas is coming together with the tyre oil gas. The cost for storing this waste gas is more than the profit this waste gas can give. So usually this waste gas is burnt for heating the reactor.Waste rubber refining equipment

2. Carbon black gets accumulated at its oil-out pipe. How it can be auto-shifted to the store?

In the reactor, there is weld spiral plate on inwall. When one batch finished, cool down the reactor for several hours. Open the carbon black slag door, let the reactor rotating in the opposite way, the carbon black will be transferred out automatically. Then you can dig a pool beside the carbon black door, the carbon black will drop into the poor, then you can use the spiral carbon black dregs machine to help.

3. They say that oil should be removed from the tank before running next batch. Then whether another oil tank is required so that we can produce continuously?

Yes, they are right, the oil shall be pumped out before running next batch. We provide the oil pump. For the oil tanks, we can’t provide very big one, because the containers don’t have enough space. The customer need to prepare one big oil tanks by himself. Waste rubber refining equipment

4. What is the application of raw carbon black?

Usually, the carbon black is sold out directly as rough carbon black. Or the carbon black can be refined again, become good carbon black with a higher mesh.

5. What about the steel wire? How to remove it?

Steel removal is a big question, as it gets entangled in the reactor. Now, the steel is easy to be out. When the carbon black finish discharging there is only bunches waste steel inside the reactor. Then pull it out. You can use the steel wire hook in the auto feeder, it is very convenient.