MODEL

TLA-3W-A

TLA-3W-B

TLA-3W-C

OUTPUT

DC VOLTAGE

12V

12V

12V

LED OPERATION VOLTAGE

6-12V

6-12V

6-12V

RATED CURRENT

300mA

320mA

350mA

CURRENT RANGE

0-300mA

0-320mA

0-350mA

CURRENT ADJ. RANGE

75% ~ 100%

RATED POWER

3.6W

3.84W

4.2W

RIPPLE & NOISE (max.) Note.2

300mV

300mV

300mV

LINE REGULATION

3%

LOAD REGULATION

5%

SETUP TIME

1-3S

INPUT

VOLTAGE RANGE Note.4

90-264VAC

FREQUENCY RANGE

50 ~ 60Hz

POWER FACTOR (Typ.)

EFFICIENCY (Typ.)

73%

73%

73%

INRUSH CURRENT (max.)

30Amax

PROTECTION

SHORT CIRCUIT

Hiccup mode, recovers automatically after fault condition is removed

OVER VOLTAGE

13-16V

13-16V

13-16V

Protection type : Shut down and latch off o/p voltage, re-power on to recover

ENVIRONMENT

WORKING TEMP.

-20 ~ +50 (Refer to "Derating Curve")

WORKING HUMIDITY

20 ~ 90% RH non-condensing

STORAGE TEMP., HUMIDITY

-40 ~ +80 , 10 ~ 95% RH

SAFETY&EMC

SAFETY STANDARDS

EN61347-1, EN61347-2-13

WITHSTAND VOLTAGE

I/P-O/P:3.0KVAC

EMC EMISSION

Compliance to EN55015,EN61547,EN61000-3-2,3

QTHERS

LIFE

2 years

DIMENSION

40*27*22mm (L*W*H)

PACKING

Carton

NOTE

1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25°C of ambient temperature.

2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.

3. Tolerance: includes set up tolerance, line regulation and load regulation.

4. Constant current operation region is within 75% ~100% rated output voltage. This is the suitable operation region for LED related applications, but please reconfirm special electrical requirements for some specific system design.

5. Derating may be needed under low input voltages. Please check the static characteristics for more details.

6. A type and C type only.

7. Safety and EMC design refer to EN61347-1, EN61347-2-13 ,EN55015,EN61547,EN61000-3-2,3

8. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.