XF-10 High profitable automatic plastic waste management

Our equipment which can transfer the waste tyres or the plastics into oil in normal pressure.

In general 10ton waste tyres can get 5 ton oil,the oil through the distillation can get diesel .

There is no pollution to the air, the system not only can solve the waste tires/plastics,

pollution in your country but also can bring much profit for you.

2.Pyrolysis: This part will produce high temperature oil gas, the oil gas then flow into the next system.

3.Condensing:Oil gas come out from the reactor then cooling down in this part.Condensing system

include cndenser pipe,oil water separator,horizontal condenser and waste gas condenser. This will

make the oil yield to the maximum.

4.Waste gas recovery: This part mainly deal with the gas cannot be condensed.The whole process is

steady and high efficiency.

The advantages of auto-feeding machine: Saving time and labor, Increasing the amount of feeding,Safety.

The smaller the tire is, the more it can be pushed into reactor. Normally, a 10T reactor can load 9-10T if it

is fragment.

1.The material of reactor is Q245R boiler steel.( 16mm ) The melting point of Q245R is 1000°C.

2.And the catalyst room has a function of reducing the pressure, dusting, and buffer action. It can slow

down the oil gas to make subsequent cooling more fully and ensure the rate of oil out put.

1.Improve the oil yield and oil quality.

2.Reduce the speed of the oilo gas so that it can be better cooled.

1.After the temperature of reactor cooled down to 50degrees, anticlockwise rotate the reactor by using

reversed principle of spiral plate, in this way,the carbon can be discharged automatically.

Then the carbon black can send out by spiral conveyor. After that the steel wire can be pull out by steel

wire hook.

1.Using coal and wood as fuel will exist black smoke, especially when we use coal,

there have so2 in the black smoke.

2.We need a pool and put some lime (CaO) into it.

3.The newest equipment is dual desulfurization and dust removal device, there are 20 high-pressure

nozzles in dust removal device, the dust remover can press atomizing water into high-pressure nozzles

by water pump,and atomizing water react with the so2to reach neutralization reaction,

some big particle will be prevented by the water and flow into the pool.

1.There are pressure gauges, safety valve and temperature gauge between the oil outlet and catalyst room.

2.First you should set the pressure value as 0.3mpa, when the reactor’s inner pressure value exceed it,

the alarm will ring and the safety valve willopen in a few minutes, then let oil gas out to ensure safety.

1. What does your machine can get after pyrolysis waste tire?

From waste tire to tire 45%-50% oil,30% carbon black, and 15% tire steel and rest pyrolysis gas.

2. How to process carbon black?

Make carbon black into briquette which has 4000-5000 kilocalories, or could make it into color master batch.

3. If the tire crude oil quality cannot meet our local demands, what can we do?

Tire oil can be further refine and get tire diesel which are the yellow color oil very clean energy.

4. What is ur plant area space need?

Usually 33 feet width and 131 feet length for the 10 tons capacity machine

5. How to process the waste gas/pyrolysis gas from inside reactor?

We have the professional system to reuse the pyrolysis gas back to the heating system to burn. Save ur fuel cost.