outdoor utp cat5e communication cable

4 pair utp cat6 network cables 305m

Over View

Application structured cabling, CCTV system , Alarm system , Telecom project etc.Compared with cat5 and cat5e,CAT6 CABLE features more stringent specifications for crosstalk and system noise. Can be used for voice, integrated service data network (ISDN), ATM155Mbps,100 Mbps TPDDI , fast ethernet and gigabit ethernet.Long transmission distance, small transmission loss, wear resistance, resistance to pressure.

Products Structure

Comparison of UTP/FTP/SFTP

Price	High	SFTP>>FTP>>UTP	Low
Flexible	Flexible	UTP>>FTP>>SFTP	Inflexible
Didturbance resistant	good	SFTP>>FTP>>UTP	Bad

Comparision of Cat5e&Cat6

	Cat5e	Cat6
Maximum length	100m	100m
Bandwidth	100Mhz	250Mhz
Disturbance resistant	Normal	Good
Suitable for	100BASE-TX (Fast Ethernet)	1000BASE-T (Gigabit Ethernet)
Diamater	5.2mm	5.8mm
Theoretical download	12.8 M/s	128 M/s

About Cat5e system

1000Base-T is the standard applied by the Cat5e system during the Gigabit Ethernet transaction, which could run

properly on the Cat5 Twist-Pair that meets the standard of ANSI/TIA/EIA-568A(1995).1000Base-T would finish the data transaction by applying to 4 pairs of Cat5 Twist-Pair and each of them is responsible for a 250Mbps data flow. However, as the designed bandwidth is only 100MHz

for the Cat5 & Cat5e Twist-Pair, it must satisfy some special requirements to achieve the two-way transmission within the 1000Mbps network.

About Cat6 system

1000BASE-Tx is the working style for Cat6 system. Similarly, 1000Base-Tx works on the basis of 4 pairs of

Twist-Pair; but two of them are for sending while the other two are for receiving(similar to the 100Base-TX, who sends and receives data respectively by two Twist-Pair). Each pair of cables doesn’t conduct a two-way transmission themselves; therefore the crosstalk between cables decreases greatly, along with a relatively

simple coding way. Such kind of technology has a lower requirement on the network interface. It doesn’t require quite a complicated circuit design thus the cost on network interface is decreased. Whereas, along with

the efficiency decrease of the used cables (two for sending and two for receiving), the bandwidth is required to

be over 100mhz so as to achieve a 1000mbps transmission speed;i.e. such kind of network is not supported in

the Cat5&Cat5e system but will only be supported by the Cat6 system.

OurhotsaleCAT6products:

Our hot sale CAT5E products:

Thank you for your time!